Network Device Connect Fail - Huawei ECC500 User Manual

ECC500
User Manual

6.2.6 Network Device Connect Fail

Description
This alarm is generated when a networked device is disconnected from the ECC500.
Attribute
Alarm ID
-
Impact on the System
After this alarm is generated, the device keeps running but prompt maintenance is required.
Possible Causes




Procedure
Step 1 Check whether the communications cable between the ECC500 and the networked device is
disconnected.


Step 2 Check whether the parameters are correctly set for the networked device. For details, see
Adding a Networked


Step 3 Check whether the network is proper.


Step 4 Check whether the networked device is faulty.


----End
Issue 03 (2020-01-06)
The communications cable is disconnected.
Parameters are incorrectly set for the networked device.
The network is unstable.
The networked device is faulty.
If yes, reconnect the communications cable.
If no, go to Step 2.
Device.
If yes, go to Step 3.
If no, reset the communications parameters.
If yes, go to Step 4.
If no, repair the network.
If yes, repair the networked device.
If no, contact Huawei technical support.
Copyright © Huawei Technologies Co., Ltd.
Alarm Severity
Warning
6 Maintenance and Troubleshooting
Alarm Type
Alarm
5.2.5
81