Adding A T/H Sensor - Huawei ECC500 User Manual

ECC500
User Manual
Parameter
Equipment Address
Timeout
Step 6 Click Add Equipment.
----End
Follow-up Procedure
If the device addition fails, check whether the settings are consistent with the device
parameters.

5.2.3 Adding a T/H Sensor

Prerequisites



Context
After connecting a T/H sensor to the ECC500, add the T/H sensor on the ECC500 WebUI.
Procedure
Step 1 Log in to the ECC500 WebUI.
Step 2 Choose Home > Equipment Manage.
Step 3 Select Temp/Hum from the Equipment Type drop-down list box and set device parameters,
as shown in
Issue 03 (2020-01-06)
A T/H sensor is connected to the ECC500. The ECC500 has been powered on.
You have obtained the ECC500 IP address as well as the user name and password for
WebUI login.
You have prepared a PC which is in the same IP address segment as the ECC500 and
connected the PC to the ECC500 over a switch.
Figure 5-9. Table 5-3
Copyright © Huawei Technologies Co., Ltd.
Setting
In this example, set Equipment Address to 1. Set the
actual device address of the UPS2000G during
operations.
The default timeout interval is 2s. Set the parameter to
the required value.
describes the setting methods.
5 UI Description
53