Table of Contents
Advertisement
1. Attach an ESD strap to your wrist. Attach the other end of the strap
2. Perform an operating system shutdown if you are not removing the
3. Remove chassis or system cover(s) as necessary for access to the
4. With the transition module (CPTM-01) in the correct vertical
5. Secure in place with the screws provided, making good contact with
6. Replace the chassis or system cover(s), making sure no cables are
http://www.motorola.com/computer/literature
to the chassis as a ground. The ESD strap must be secured to your
wrist and to ground throughout the procedure.
CPN5365. Turn the AC or DC power off and remove the AC cord
or DC power lines from the system. If you are not powering off the
system, first remove the CPN5365 before installing the RTM.
chassis backplane.
position that matches the pin positioning of the corresponding
CPN5365 board, carefully slide the transition module into the
appropriate slot and seat tightly into the backplane. Refer to the next
figure for the correct connector orientation.
the transverse mounting rails to minimize RF emissions.
pinched.
Installing the CPTM-01 Transition Module
Transition Module
Single Board Computer
2165 9803
2
2-5
Advertisement
Table of Contents
