Table of Contents
Advertisement
Antistatic Precautions
Use ESD
Motorola strongly recommends that you use an antistatic wrist strap and a
conductive foam pad when installing or upgrading a system. Electronic
components, such as disk drives, computer boards, and memory modules,
can be extremely sensitive to electrostatic discharge (ESD). After
Wrist Strap
removing the component from its protective wrapper or from the system,
place the component flat on a grounded, static-free surface (and, in the case
of a board, component side up). Do not slide the component over any
surface.
If an ESD station is not available, you can avoid damage resulting from
ESD by wearing an antistatic wrist strap (available at electronics stores)
that is attached to an active electrical ground. Note that a system chassis
may not be grounded if it is unplugged.
Dangerous voltages, capable of causing death, are present in this
equipment. Use extreme caution when handling, testing, and adjusting.
Warning
Avoid touching areas of integrated circuitry. Static discharge can damage
these circuits.
Caution
Installing the CPTM-01 Transition Module
The CPTM-01 transition module may be required to complete the
configuration of your particular CPN5365 system. If so, perform the
following steps to install this board.
Please read all cautions, warnings and procedures before installing the
CPTM-01 into your chassis.
Note that models of the CPN5365 that include the J4 connector must not
!
be installed in enclosures that have support buses like the H.110 or provide
other uses for this J4 connector. Also, the CPTM-01 should only be
Caution
http://www.motorola.com/computer/literature
Installing the CPTM-01 Transition Module
2
2-3
Advertisement
Table of Contents
