Motorola CompactPCI CPN5365 Installation And Use Manual page 40

Single board computer and cptm-01 transition module

Table of Contents

1. Open the injector levers on your board (see

2. Verify the proper slot for the module you are inserting (see

3. Using your thumbs, apply equal and steady pressure as necessary to

4. Use the injector levers to seat the module in the slot by closing the

5. When the module you are installing is completely latched, secure it

http://www.motorola.com/computer/literature

Stage 1

Injector/Ejector Lever Types on page

Slot Usage on page

1-17). Align the edges of the module with the

card cage rail guides in the appropriate slot.

carefully slide the module into the card cage rail guides (Stage 1).

Continue to gently push until the prealignment guide pegs engage

with the backplane connector (Stage 2) and the injector levers make

contact with the chassis rails. DO NOT FORCE THE BOARD INTO

THE BACKPLANE SLOT.

levers until they latch into the locked position (Stage 3). If the levers

do not completely latch, remove the module from the chassis and

visually inspect the slot to ensure there are no bent pins.

by tightening the captive screws at both ends of the faceplate.

Stage 2

(Detail)

Stage 2

Recognize Different

1-16).

Installing a Module

4200 0804

Stage 3

Verify

1-19

Table of Contents

Compactpci cptm-01