Nordson Spectra 30 HMI Instruction Sheet

Instruction Sheet
Spectra 30 HMI Kit - P/N 1123817
This instruction sheet describes how to replace the touch screen panel in
the Spectra 30 pattern controller.
Touch Screen Panel
P/N 1123825
WARNING: Risk of personal injury or equipment damage! Refer to
the safety information provided in the melter manual before servicing
the melter. Failure to comply with the safety information provided can
result in personal injury, including death.
Replacing the Touch Screen Panel
Warning:
Allow only personnel with appropriate training and experience to
operate or service the equipment. The use of untrained or
inexperienced personnel to operate or service the equipment can
result in injury, including death, to themselves and others, and
damage to the equipment.
1.
Turn off the pattern controller switch and disconnect the
input power supply.
2.
Unfasten the four captive screws (see a in
Figure 1) to remove the pattern controller front cover.
a
Figure 1
a: Four captive screws
Required Tools:
4 mm hex key
Large flat screwdriver
3.
Remove the display ribbon cable (see c in Figure 2)
by lifting up the cable connector lock tabs and carefully
pulling it out.
4.
Unfasten the two captive screws that hold the
touch screen panel to the base panel (see d in
Figure 2).
5.
Unfasten the two screws (see e in Figure 2)
that hold the touch screen panel to the metal plate
holder.
6.
Remove the touch screen panel (see a in
Figure 2) by compressing the standoffs (see b
in Figure 2).
a
e
d
Figure 2
a: Touch screen panel b: Standoffs
c: Ribbon cable d: Two captive screws
e: Screws
10/2014
b
c
Continue