Table of Contents
Advertisement
UpdateFailed
Rescue Network
Enabled
BootOnRecoveryBank
Automatic network
configuration in progress
No network address set
NetworkRescue
© 2014 Aastra Sweden | 154_1531 ANF 901| A | 2014-05-15
Triggered after a failure of a firmware
pack download operation. After 4
seconds, the unit restarts.
Triggered after the user has
performed a partial reset procedure.
Triggered when the unit is booting on
the recovery bank and no update is
pending.
Waiting for DHCP (IPv4 or IPv6)
answer or IPv6 router advertisement
or PPPoE connection.
Triggered when the unit cannot be
contacted because DHCP failed, PPP
failed, and no static interface is
configured.
The unit tries to download and install
a firmware given by the Network
Rescue server.
23
TA7104i Hardware Installation
All LEDs:
•
blinking at 3Hz,
50% duty. One LED out
of two has a 180 degree
phase. This pattern lasts
for 8 seconds.
Power and In Use LEDs:
•
blinking
(synchronized)
1Hz, 75% duty
Power LED:
•
blinking, 0.25Hz,
75% duty
All LEDs:
•
Blinking green,
3Hz, 50% duty
Power LED:
•
blinking, 3 Hz, 50%
duty.
Ready LED:
•
Off
All other LEDs:
•
blinking to show a
LED displacing light from
left to right and right to
left.
Advertisement
Table of Contents
