Table of Contents
Advertisement
Wall-Mounting
•
To wall-mount the TA7104i:
1. Disconnect all of the cables from the TA7104i before mounting.
2. Ensure that the wall you are using is smooth, flat, dry and sturdy. Attach a piece of plywood,
approximately 250 mm x 200 mm x 12 mm (10 inches x 8 inches x 0.5 inches) securely to
the wall, if necessary.
3. If not already done so, apply the Bumpon TM authoadhesive protective products to the bottom
of the TA7104i . These will improve airflow under the unit.
4. Position the TA7104i against the wall (or plywood) as illustrated in Figure 4.
Figure 4: Bottom View - Wall Mounting Screw Holes
5. Mark the position of the screw holes on the wall. Drill the two holes and install two screws.
6. Place the screw holes of the TA7104i over the screws installed in the previous step.
7. Proceed to Hardware Installation.
Free Standing Unit
When installing the TA7104i on a desk or table, it should be located at least 20 cm from your
monitor, computer casing or other peripherals, including speakers. Never put books or paper on
the TA7104i.
© 2014 Aastra Sweden | 154_1531 ANF 901| A | 2014-04-15
You can position the TA7104i any way you want.
Rear
Screw holes
Front
15
TA7104i Hardware Installation
Advertisement
Table of Contents
