Aastra TA710i Hardware Installation Manual page 10

Standards Supported -ITU-T I.430 Basic user-network interface - Layer 1
specification (section 9).
Figure 2: TA7104i Rear Panel Connectors
Table 3 describes the rear panel connections (from left to right).
1.
2.
3.
4.
5.
7.
© 2014 Aastra Sweden | 154_1531 ANF 901| A | 2014-05-15
Connection
Power connector
Reset / Default switch
USB connector
ETH1
ETH2
FXS Port 1 - 4
External 12 Vdc power supply. The TA7104i uses
• a 1.5A power supply.
Resets configuration parameters of the TA7104i to default
(known) values. It can be used to reconfigure the unit.
Warning:
Read Section
before attempting to reset the unit.
TBD
A 10/100 BaseT Ethernet RJ-45 connector for access to a LAN, WAN
or computer. This port is by default used for uplink / WAN connection.
A 10/100 BaseT Ethernet RJ-45 connector for access to a LAN, WAN
or computer. This port is by default used for LAN connection.
4 x RJ-11 connectors to attach a conventional telephone or G3 fax
machine.
9
TA7014i Hardware Installation
Description
"RESET/DEFAULT Button" on page 18