Table of Contents
Advertisement
are the last 6 digits of the unit's MAC address. Example: The link local address for the
TA7104i with MAC address 00:90:F8:12:34:56 would be [fe80::290:f8ff:fe12:3456].
Note: On Windows, a scope ID needs to be added to the link local address
([fe80::290:f8ff:fe12:3456%11]). You can find this number by executing the 'ipconfig' command
in a command prompt. Note the number at
the end of the IPv6 default Gateway for the interface used to contact the unit.
On Linux, the scope identifier may be the link name or the interface number. The interface
number can be determined through the Linux command line.
Vocal Unit Information
When entering special characters on your telephone pad, the TA7104i talks back to you with
relevant information.
• To access vocal unit information:
1. Take one of the telephones connected to the TA7104i.
2. Dial one of the digits sequence on the keypad.
Table 4: Vocal Unit Information
Verifying the Installation
There are a few ways to verify that the TA7104i is properly connected to the IP network and is
working:
•
By contacting it with a SNMP browser
•
By contacting it via the CLI
•
By contacting it via a web browser
•
By pinging it
These procedures assume that you know the IP address of the TA7104i you want to verify. If
the TA7104i does not respond, do the following:
•
Verify that the LAN and WAN cables are securely connected to the TA7104i and to the
network connectors.
•
Be sure that you did not connect crossover network cables.
•
Verify the state of the IP network to ensure it is not down (the ETH LED should be ON or
blinking).
© 2014 Aastra Sweden | 154_1531 ANF 901| A | 2014-05-15
Digits to Dial
*#*0
*#*1
Information Vocally Sent by the TA7104i
Current IP address of the TA7104i (static or DHCP).
MAC address of the TA7104i.
21
TA7104i Hardware Installation
Advertisement
Table of Contents
