Indicators (Leds) - Aastra TA710i Hardware Installation Manual

Indicators (LEDs)

4.2
The indicators (LEDs) of the TA7104i are described in TA7104i Connectors and Indicators.
LED Patterns – Specific Conditions
Table 5 describes the different states a Aastra unit can have and their associated LED patterns.
Table 5: LED Patterns
Condition
RestartPending
RecoveryPending
DefaultSettingsPendin g
UpdateInProgress
© 2014 Aastra Sweden | 154_1531 ANF 901| A | 2014-05-15
Description
Triggered when the
RESET/DEFAULT button is pressed
in the ResetPending state. The unit
prepares for a physical shutdown and
restart.
Triggered when the
RESET/DEFAULT button is pressed
at start-time or for at least 7 seconds.
Triggered when the
RESET/DEFAULT button is not
released while in ResetPending state.
At run time, if the RESET/DEFAULT
button is released within 5 seconds,
the unit applies default settings,
otherwise the action is cancelled and
the unit goes back to the operation
mode state or it resets.
At start time, the unit stays in this
state until the RESET/DEFAULT
button is released. The unit then
applies the default settings and
restarts.
A firmware pack is downloaded into
the unit and written to persistent
storage.
22
TA7104i Hardware Installation
LED Pattern
Power LED:
• blinking, 1Hz, 50%
duty
All other LEDs:
• OFF
All LEDs:
• blinking, 1Hz, 50%
duty
All LEDs:
• steady ON
All LEDs:
• cycling from left to
right, individually blinking
1Hz, 33% duty