Fujitsu BS2000 SE Series Operating Manual page 32

Server Unit /390
4 START
5 SYSTEM DUMP
6 LOAD CLEAR
7 LOAD NON CLEAR
Functions 6 or 7 must be used for an IPL from a real or emulated tape device. In addition, function 3 must be
selected at MT CONTROL (see
IPL DEVICE By entering the corresponding number in this field you can specify from which device group an
==> IPL is to be executed.
1 PRESET
GROUP
2 CURRENT
GROUP
3 UNIT
ADDRESS
PARMS => A maximum of 8 characters can be entered in this field. Their position and meaning are listed
below:
Position 'BLANK'
1 1
Position mn
2 - 5
Position
6 - 8
MT CONTROL ==>
1 NL
2 SL
not used
executes SLED
clears main memory before IPL
does not clear main memory before IPL
"(LD) PROGRAM LOAD FRAME: DETAIL-1"
The first device address in this column is the device from which an IPL is to be executed.
The order and number were specified previously in (AU5) AUXILIARY FRAME: LOAD
PRESET-1.
If IPL is terminated normally, the device address list is transferred from the PRESET
GROUP to the CURRENT GROUP.
If the IPL is unsuccessful, the next device address from the PRESET GROUP is reloaded.
If this loading is terminated normally, this device address heads the CURRENT GROUP.
The first device address in this column is the device from which the last IPL was executed.
If the loading from this device is unsuccessful, the IPL is repeated with the next device
address. If it is terminated normally, this address then heads the CURRENT GROUP.
A new device address from which the operating system is to be loaded can be entered
here. If the IPL is terminated normally, this device address is put in the first position in the
CURRENT GROUP.
If the IPL is unsuccessful, the loading is not repeated.
loading BS2000
loading VM2000
The mnemonic pair of an SKP console can be entered here if the standard consoles
with the mnemonic pairs C2C3 and C4C5 are not available for the IPL.
not used
IPL from tape:
from current tape position
skip label then load
).
32