Table of Contents
Advertisement
217-6327-752
VersaChassis Mini 4 Wheel Drive Assembly Instructions
Step 1: Drilling Wheel Holes
Use a 7/8" (or larger) Step Drill to drill (2X) 3/4" – 7/8" diameter holes in the center of the
tube and approximately 2.50" from the end of the tube. The center of tube is marked by a
scribe line that is put on every piece of VersaFrame tubing. This scribe line not only shows you
where the center of the tube is, but also makes it harder for your drill bit to 'walk', or shift,
while you're drilling the hole.
These holes must go through both sides of the tube. As indicated below, one of these holes
will be pre-drilled into the frame. The other will require you drill a new hole.
Note:
The instructions below allow teams to run both 3.25" and 4" wheels. If you wish to run
wheels larger than 4", you will need to move both holes closer to the center of the chassis
side rail.
vexpro.com
Copyright 2018, VEX Robotics Inc.
8
2018-06-15
Advertisement
Table of Contents
