Part 3: Versaplanetary Lite Assembly - Vex Robotics Pro VersaChassis Mini Assembly Instructions Manual

217-6327-752
VersaChassis Mini 4 Wheel Drive Assembly Instructions

Part 3: VersaPlanetary Lite Assembly

This section covers the assembly of the VersaPlanetary Lite gearboxes. Before continuing with
this section, the motors you plan on using should have any pre-installed pinions and gearbox
mounting plates removed. If you haven't done this, please refer to the guide "Preparing FTC
Motors For Use With The VersaPlanetary" for more information.
Note: These steps will need to be performed for each of the VersaPlanetary Lite gearboxes
being used with the VersaChassis Mini.
When completed with Part 3, you will end up with four
completed VersaPlanetary Lite gearboxes with a 1/4" Square
shaft installed.
vexpro.com
Copyright 2018, VEX Robotics Inc.
2018-06-15
18