Table of Contents
Advertisement
FlexxPump 250/400 (24V); time-controlled
User Manual
9.1
Lubricants
Only use lubricants approved by the manufacturer DLS Schmiersysteme GmbH in the
original cartridges developed and manufactured exclusively for FlexxPump 250/400.
Further information on lubricants, documentation and safety data sheets can be
obtained directly from the manufacturer DLS Schmiersysteme GmbH.
9.2
Tube length
In principle, the recommendation is to install the FlexxPump 250/400 as close as
possible to the consumer (lubrication point). Ideally, this should be done directly at or
on the lubrication point. In cases where this is not possible due to the installation space
or for reasons of reachability or accessibility, tubes can also be used between the
FlexxPump 250/400 and the lubrication point (or distributor).
If the case arises that you cannot mount the FlexxPump 250/400 directly at the
lubrication
point, contact the manufacturer to verify your application. The influence of temperature,
the grease used, the hoses and accessories used does not allow a general statement
to be made about the possible hose length on the FlexxPump 250/400.
revision: 1
The lubricant used in each case differs according to the
application. The respective designation can be found on the
label of the cartridge.
NOTICE
EN-
57
Advertisement
Table of Contents
Need help?
Do you have a question about the FlexxPump 250 and is the answer not in the manual?