Table of Contents
Advertisement
Note: (The requirement of professional repairers' regulation by ERP lot5)
1) The professional repairer has the technical competence to repair electronic displays and complies with the
applicable regulations for repairers of electrical equipment in the Member States where it operates. Reference
to an official registration system as professional repairer, where such system exists in the Member States
concerned, shall be accepted as proof of compliance with this point.
2) The professional repairer is covered by insurance covering liabilities resulting from its activity, regardless of
whether this is required by the Member State.
USB 3.0 TYPE A CN1101 CN1102
Repair the usb connector:
1)
Use a hot air gun to melt the solder on the pins. Pin solder with soldering iron and absorber. You can gently push
down with the soldering iron once everything is molten to move the CN1101 out of the through holes.
2)
Lift the CN1101 connector from the PCB.
3)
Place the new component on the PCB. Be sure that it matches the PCB footprint.
4)
Solder the new component.
PHONE JACK CN601
Repair the PHONE JACK connector:
1) Use a hot air gun to melt the solder on the pins. Pin solder with soldering iron and absorber. You can gently
push down with the soldering iron once everything is molten to move the CN601 out of the through holes.
2) Lift the CN601 connector from the PCB.
3) Place the new component on the PCB. Be sure that it matches the PCB footprint.
4) Solder the new component.
19
Advertisement
Table of Contents
