Table of Contents
Advertisement
CHECKING FOR CONTACT IN CASE OF HIGH TEMPERATURES
If necessary, temporarily remove the water block to check for
uniform surface contact between the block and components.
Pay special attention to the VRM section of the graphics card.
Check whether the water block makes contact with the intended
integrated circuit. Then repeat Steps from the previous section to
re-attach the block.
In case you fail to obtain good contact, please check again or contact
our support service at https://www.ekwb.com/customer-support/.
- 15 -
Advertisement
Table of Contents
Need help?
Do you have a question about the EK-Quantum Vector XC3 RTX 3080 D-RGB and is the answer not in the manual?
Questions and answers