Connecting The D-Rgb Led Strip; Testing The Loop - ekwb EK-Quantum Vector XC3 RTX 3080 D-RGB User Manual

Gpu water block
Table of Contents

Advertisement

CONNECTING THE D-RGB LED STRIP

TESTING THE LOOP

To ensure the installation of EK components was successful, we
recommend you perform a 24-hour leak test.
When your loop is complete and filled with coolant, connect the pump
to a PSU outside your system. Do not connect power to any of the other
components. Turn on the PSU and let the pump run continuously.
Inspect all parts of the loop, and in case the coolant leaks, fix
the issue and repeat the testing process. To prevent possible
damage, please ensure that all hardware is dry before you power
on the system.
D-RGB HEADER
RGB HEADER
STEP 1
- 14 -
STEP 1
Plug the 4-pin D-RGB connector from the GPU water block to the
D-RGB Header on your motherboard or controller. The LED strip will
work only if the pin layout on the header is as follows: +5V, Data,
Empty, Ground.
Incorrect installation or installation to a wrong header can
damage the LED strip or the header itself!

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EK-Quantum Vector XC3 RTX 3080 D-RGB and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Ek-quantum vector xc3 rtx 3090 d-rgb3831109832653

Table of Contents