Before Operation; Sound; Adjusting The Sound - Aiwa CSD-EL50 Operating Instructions Manual

BEFORE OPERATION
ADJUSTING THE SOUND
POWER
Function
To turn the unit on
Press one of the function buttons (TAPE, TUNER, CD).
Playback of the inserted disc or tape begins, or the
previously tuned station is received (Direct Play Function).
The POWER button is also available.
The disc compartment may open and close to reset the unit.
After use
Press the POWER button to turn off the power. The display
changes to the clock.
NOTE
When using on the batteries, you cannot turn the power on
with the remote control.
Using the headphones
Connect headphones to the (_l PHONES jack on the rear of
the LInit with a stereo mini plug (03.5 mm,
'/8
inch).
No sound is output from the speakers while the headphones
are plugged in.
VOLUME CONTROL
Turn the VOLUME/TIMER control on the main unit or press
the VOLUME buttons on the remote control.
SUPER T-BASS SYSTEM
l-he T-BASS system enhances the realism of low-frequency
sound,
Press the T-BASS button.
"ro cancel, press the button again.
INOTE
Low frequency sound may be distorted when the T-BASS
system is used for a disc or tape in which low frequency
sound is originally emphasized. In this case, cancel the T-
BASS system.
QSOUND SYSTEM
The QSOUND system provides a rich, three dimensional
sound area.
You can enjoy more enhanced sound.
Press the QSOUND button.
To cancel, press the button again
NOTE
At higher volumes, turning QSOUND on may cause sound
distortion. In this case, turn the volume down.
EQUALIZER MODE
Press the 3-MODE EQUALIZER button until the desired
equalizer mode is displayed.
The equalizer mode changes to ROCK, POP, JAZZ or no
equalization, cyclically.
When using the remote control, press the EQ button.
ROCK Powerful sound emphasizing treble and bass
POP: More presence in the vocals and midrange
JAZZ Accented lower frequencies for jazz-type music
ENGLISH
5