Power Supply; Remote Control - Aiwa CSD-EL50 Operating Instructions Manual

POWER SUPPLY
REMOTE CONTROL
USING ON AC HOUSE CURRENT
Connect the AC cord as illustrated below.
inlet of the unit
0 to an
AC
outlet
CAUTION
Use only the supplied AC cord. Use with other cords may
result in the risk of fire.
USING ON BATTERIES
Open the lid of the battery compartment on the rear and
insert eight R14 (size C) batteries, not supplied, as illustrated
below. Then close the lid.
To switch from AC power supply to battery power
supply, disconnect the AC cord from the AC inlet.
The batteries need to be replaced when:
The OPE/BATT indicator becomes dim, the tape speed
slows down, volume decreases, or sound is distorted during
operation.
Notes on batteries
To avoid damage from leakage or explosion, observe the
following:
Insert the batteries with the 0 and
O
marks correctly
aligned.
Do not mix different types of batteries or old batteries with
new ones.
Never recharge the batteries, apply heat to them or take
them apart.
Remove dead batteries.
If liquid leaks from the batteries, wipe thoroughly to remove.
Inserting batteries
Detach the battery cover on the rear of the remote control
and insert two R6 (size AA) batteries.
When to replace the batteries
The maximum operational distance between the remote
control and the sensor on the main unit (REMOTE SENSOR)
should be approximately 5 meters (16 feet), When this
distance decreases, replace the batteries with new ones.
REMOTE SENSOR
Using the remote control
The instructions in this manual refer mainly to the buttons on
the main unit. Buttons on the remote control with the same
names as those on the main unit can be used as well.
NOTE
If the unit is not going to be used for an extended period of
time, remove the batteries to prevent possible electrolyte
leakage.
The remote control may not operate correctly when:
- The line of sight between the remote control and the unit
is exposed to intense light, such as direct sunlight
- Other remote controls are used nearby (television, etc.)
SHIFT—
FUNCTION—
3
Q9a'
C20a
000
902
moo,
000
000
moo
To use the SHIFT button
—--'a
Buttons @ have two different functions. One of the functions
is indicated on the button, and the other on the plate above
the button.
To use the function on the button, simply press the button.
To use the function on the plate above the button, press the
button while pressing the SHIFT button.
To use the FUNCTION button
The FUNCTION button substitutes for the function buttons
(TAPE, TUNER, CD) on the main unit. Each time the
FUNCTION button is pressed while the power is on, the next
function is selected cyclically.
4
ENGLISH