Start And Adjust The Elevator - Graco SaniForce 24V310 Instructions - Parts Manual

5. With your hands away from the drum, set the
elevator director switch to DOWN.
Fully lower the pump into the drum. Mobile
models: Lock the cart wheels.
6. Loosen the u-bolt on the articulating arm. Raise
the arm until the pump is just off the bottom of
the drum. Block the pump to hold it in place, then
tighten the u-bolt on the articulating arm.
NOTE: The pump mounting bracket can connect
anywhere on the tie rods. Start with it connected in
the center, and adjust as needed for proper travel.
333406A
Springer Pumps, LLC
Telford, PA 18969

Start and Adjust the Elevator

1. Close all air regulators and air valves.
2. Open the main air valve.
3. Set the elevator director switch to UP.
4. Stationary Models: Set a full 200 liter (55 gallon)
5. With your hands away from the drum, set the
6. To increase or decrease the speed of downward
7. The speed of upward travel on the elevator is
Tel: 866-777-6060 / Int'l: 215-949-2900
Fax: 866-777-6383 / Int'l: 215-721-1296
Slowly increase regulator pressure until the
elevator rises to its full height.
NOTE: Generally, 40 to 70 psi (0.3 to 0.48 MPa,
3 to 4.8 bar) is sufficient to raise the elevator.
drum against the elevator base.
Mobile Models: Move the cart into place by a full
200 liter (55 gallon) drum.
elevator director switch to DOWN.
Fully lower the pump into the drum. Mobile
Models: Lock the cart wheels.
NOTE: When the elevator is fully lowered, the
pump should be just off the bottom of the drum.
See Set Height of Articulating Arm, page
travel on the elevator, remove the side panel of
the air controls. Adjust the bleed valve (249) as
needed, clockwise for faster, counter-clockwise
for slower. Put the side panel back on. Do not
operate the elevator with the side panels off.
controlled by the regulator pressure.
Operation
14.
15
shop.springerpumps.com
info@springerpumps.com