Troubleshooting - Sony LIB-D81 Product Description Manual

A.5. Troubleshooting
3
Extract the air filter from the AIT autoloader.
Caution
Take care not to cut yourself on the metal corners of the air filter.
4
Clean the air filter with a vacuum cleaner.
5
Reinsert the air filter.
6
Close the front door.
7
Turn on the AIT autoloader.
Before contacting a Sony Service center, please check the following. If the
problem persists, contact a Sony Service center.
The AIT autoloader does not work
• Verify that the power is on.
• Verify that the power cable is connected correctly.
• Verify that the front door is closed.
• Verify that the terminator is attached correctly.
• Verify that the SCSI cable is correctly connected from the AIT autoloader to
the host computer.
• Verify that the host computer is on.
• Verify that no error code is displayed on the message display. For information
about error codes, see "Error Code List" (page 147).
• Only restart the AIT autoloader 10 seconds after it is turned off.
The AIT autoloader and the host computer cannot
communicate with each other
• Verify that the SCSI IDs of the autoloader, AIT drive, and host computer are
unique. Duplicate SCSI IDs cannot be used on one SCSI bus. t "Setting the
SCSI ID" (page 29) in Chapter 3, "Installation".
141
Appendix