3.6. Connecting the Power Cable
3.7. Connecting to the Host Computer
1
Make sure that the power switch on the rear of the AIT autoloader is in the
off position (a is depressed).
2
Connect one end of the power cable to the power supply connector and the
other end to the power outlet.
Connect the AIT autoloader and the host computer with a SCSI cable. This
section explains general connection steps. To connect, use an Ultra2 Wide SCSI
LVD cable commonly sold in stores. However, when using a model equipped
with an AIT-3 drive, use an Ultra 160/m SCSI LVD cable. The autoloader side
uses the 68-pin half pitch connector.
When connecting other SCSI devices along with the AIT autoloader, see
"Connecting SCSI Peripheral Devices" (page 30).
Caution
• Do not connect the AIT autoloader to the HVD (High Voltage Differential)
SCSI bus. If connected, the autoloader or other devices on the SCSI bus may
be damaged.
25
Chapter 3 Installation