Table of Contents
Advertisement
The soundproofing box is equipped with two
cable pressers used to let through the battery
connection cables (Fig. 7 ref. 3).
Always fit a 70 A fuse onto
the positive cable connecting the generating
set to the positive pole of the battery.
230 Volt AC
230 Volt AC
Leng. < 4 m
Leng. > 4 m
2
2
2,5 mm
4 mm
230 V LINE CONNECTION
4.5 Battery charger
The ENERGY 4000 B/4000 GAS generating sets
are provided with a battery charger which can
deliver a 10 Amp current at 12 V.
You can use it to recharge the start-up battery of
the generating set or for the service batteries of
the vehicle.
To use the battery charger, connect the positive
pole of the battery you intend to recharge - via a
2.5 mm
cross-section cable - to the proper
2
terminal (Fig. 5 ref. 6) and the negative pole to
the terminal on Figure 5 ref. 2.
The generating set does
not automatically recharge the battery used
for starting up unless it is connected to the
battery charger.
4.6 Electronic control panel connection
Choose the position you want inside the vehicle
and make a rectangular hole, 30 x 32 mm.
Fasten the electronic control panel (Fig. 8) using
self-tapping screws measuring 3 x 20 mm.
Use slight pressure to fasten the plastic frame.
The electronic control panel is provided with a 5
metre long connecting cable which must be
connected properly to the generating set using
the relevant connector (Fig. 9 ref. 1).
10
12 Volt CC
12 Volt CC
Leng. < 6 m
Leng. > 6 m
2
2
10 mm
16 mm
BATTERY CONNECTION
TAB. 1
Energy 4000 B / 4000 GAS
GB
4.7 Fuel tank installation instructions
For ENERGY 4000 B only
The fuel tank (Fig. 10) must be located so the
fuel hose (Fig. 12 ref. 2) is as short as possible.
Nor must the cross-section of the hose be
diminished by squeezing, bending or crushing.
We also suggest you install the tank at the same
height as the generating set; even if you place it
at a lower position, there must never be more
than 20 cm level difference (Fig. 10).
7
8
9
Vers. 013
Advertisement
Table of Contents
