Ghibli & Wirbel S2 Faq

PROBLEM
The machine does not turn
on when the key is turned.
The brush does not rotate.
Aspirator does not work.
The machine does not dry
well, leaving traces of water
on the floor.
No water comes out.
CAUSE
Low battery.
Main fuse blown.
Brush fuse blown.
Brush rotation enabling
switch not pressed
Aspirator fuse blown.
Suction unit switch not
pressed.
Recovery tank full.
Aspirator off.
Aspiration tube blocked.
Recovery tank full.
Squeegee rubber blades
worn.
Tank empty.
Solenoid valve enabling
switch not pressed.
Tap turned off.
Filter blocked.
Solenoid valve does not
work.
ENGLISH
S2 - SW2
SOLUTION
Check that the battery is
charged.
Replace the master 7,5A
fuse.
Replace the WHITE 25A
brush motor fuse.
Press the switch.
Replace the RED 40A fuse
for the suction unit's motor.
Press the switch.
Empty, wash and clean the
tank and the probes.
Start up the aspirator.
Check and if necessary
clean the aspiration tube
that connects the squeegee
to the recovery tank.
Empty the recovery tank.
Replace or turn over the
squeegee rubber blades.
Fill the tank.
Press the switch.
Open the tap
Clean the filter.
Call the technical support
service.
_49.0257.00