Page 2
GHIBLI & WIRBEL S.P.A. Machine type RIDE ON SCRUBBER DRYER Machine name RIDER R 65 Model RIDER R 65 RD 55 RIDER R 65 FD 65 RIDER R 65 FD 80 Net weight without/with batteries 130/210 Kg 140/220 Kg 163 / 240 Kg...
RIDER R 65 OPERATING MANUAL V02_2016 MACHINE COMPONENTS CONTROLS ANDINSTRUMENTS Plastic cover Steering wheel Squeegee lifting lever Solution tank closing lever Steering column Scrubber group lifting lever Accelerator Battery connector Footboard Water regulation lever Scrubber group Driving wheel Squeegee Brush...
RIDER R 65 OPERATING MANUAL V02_2016 FOREWORD This is a floor scrubbing machine that is able to clean a wide variety of types of flooring and types of dirt by using the mechanical action of disk or cylindrical brushes, depending on the model, and the chemical action of a water-detergent solution.
RIDER R 65 OPERATING MANUAL V02_2016 SYMBOLS USED ON THE MACHINE Brush symbol. Used to indicate the brush motor control switch, for both disk or cylindrical brushes. Aspiration motor symbol. Used to indicate the aspiration motor switch Forward/reverse speed selector symbol.
RIDER R 65 OPERATING MANUAL V02_2016 PREPARING THE MACHINE Moving the packaged machine The machine is contained in specific packing (box + pallet) with a platform so that it can be moved by a fork-lift. Total weight is 160 kg (without batteries).
Page 7
RIDER R 65 OPERATING MANUAL V02_2016 When recharging the batteries, keep the recovery tank lifted and blocked. Make sure that the battery charger fits the installed batteries both for capacity as for type. Use ONLY TRACTION batteries OPEN/PURE LEAD/ACID or GEL. Never charge a GEL battery with an unsuitable battery charger. Carefully follow the instructions given by the manufacturer of batteries and battery charger.
RIDER R 65 OPERATING MANUAL V02_2016 GENERAL SAFETY REGULATIONS Follow these regulations carefully to avoid harm to the operator and damage to the machine; The machine must be used exclusively by authorized and trained personnel; Read the labels on the machine with attention. Never cover them for any reason and always immediately replace them if they are damaged;...
RIDER R 65 OPERATING MANUAL V02_2016 OPERATION 8.1 Preparing to work Prepare the machine for operation (Read chapter “6 PREPARING THE MACHINE”); Seat in the driver's seat; Connect the battery connector to machine connector; Turn the key switch on a quarter of a turn clockwise (Position ON) Control the gear direction: forward or reverse on the specific switch on the consolle Lower the squeegeelifting lever (Fig.
RIDER R 65 OPERATING MANUAL V02_2016 AFTER WORK IS TERMINATED At the end of the work, before performing any type of maintenance proceed as follows; 1. Close the regulation cock; 2. Turn off brush motor switch; 3. Lift up scrubber group lever;...
RIDER R 65 OPERATING MANUAL V02_2016 WEEKLY MAINTENANCE 11.1 Replacing the rear squeegee rubber (Fig. 11) Proceed as follows to change the drying edge of the rear squeegee rubber if it is worn and does not dry properly: 1. Remove the squeegee;...
RIDER R 65 OPERATING MANUAL V02_2016 TROUBLE SHOOTING 12.1 Insufficient water to the brushes 1. Check that the cock is open; 2. Check that there is water in the solution tank; 3. Check that the hoses are clean and not damaged;...
Page 16
RIDER R 65 OPERATING MANUAL V02_2016 GHIBLI & WIRBEL S.p.A. Via Circonvallazione 5 - 27020 Dorno -PV- Italy Tel +39.0382.848811 - Fax +39.0382.84668 www.ghibliwirbel.com...
Page 17
DICHIARA CHE LA MACCHINA / DECLARES THAT THE MACHINE Macchina / Machine LAVASCIUGA PAVIMENTI / SCRUBBER DRIER Modello/Model RIDER R 65 Matricola/Serial Number – Anno/Year Denominazione Commerciale/Commercial Name RIDER R 65 Uso previsto/Use PULIZIA PAVIMENTI INDUSTRIALI / INDUSTRIAL CLEANING È CONFORME ALLE DIRETTIVE / CONFORMS TO...
Need help?
Do you have a question about the RIDER R 65 and is the answer not in the manual?
Questions and answers