Bonnet OPTIMUM 700 Builder’s Specifications page 28

Assembly of appliances on a masonry base
Base pace
2000
Put the appliances in place on the masonry base.
Note: If the appliances are delivered separately from the base, install the appliances on one or more bases
2000 space.
Connect electrical supply to the appliances (see paragraph 5: Installation: Connections)
Assemble the appliances between themselves.
- Fix the appliances between themselves at the back in the way of collectors with one HM5
flat washer.
- Fix the appliances between themselves at the front having removed the fascia (see paragraph 3.4)
with two HM5
Connect gas, water and drainage lines to the appliances.
Fit the trimming plinths. One front plinth per space 2000 base and one right and left end trimming plinth per
stove, depending on order.
- Assemble one or more front plinths with junctions (depending on the quantity of bases) (2 screws per
plinth).
- Fix one or more front plinths
- Fix the back part (on the end appliances before their final installation) on the base with the hex
head screw ( ).
- Fix the right and left end trimming kits ( ) (2 front screws and 1 back screw).
16 screws + 5 flat washers.
X Ø
and
2
27
Page
Possibility to lay piping
on the front
Ventilation
) onto one or more bases (two screws at least per plinth).
1
Appliance
Trimming
plinth
Base
height
at the
front
BONNET CIDELCEM GRANDE CUISINE
Siége social:
Rue des Frères Lumière - Z.I Mitry Compans
77292 MITRY MORY Cedex
3BE390582NI – 06/07
16 screw + 5
X Ø
3
4