Installation: Putting In Place; Assembly Of Cantilever Appliances To A Wall - Bonnet OPTIMUM 700 Builder’s Specifications

3.1 ASSEMBLY OF CANTILEVER APPLIANCES TO A WALL

Drilling pattern
16
892
212
131
The fixation of a bracket must support a tensile strength of 400 daN (2 brackets for a 400, 800, 1000 or
1200 wide appliance).
It is recommended, for the fixation of cantilever appliances to a concrete wall, to observe the following points:
* The reinforced concrete of the wall must be at least of quality 23 MPA (DTU).
* Use HSA-R M 8x75 plugs or equivalent (2 for cooking tops and 6 for cooking units).
* For the plugs above, each hole must be drilled to diameter 8 mm and, at least, 65 mm deep.
Procedure
- Fix the lower bearing beam of the appliances against the wall.
Warning! Check this beam is really horizontal.
- Fix the template supplied by two ∅ 5 screws to the wall. Check horizontality.
902
212

3. INSTALLATION: PUTTING IN PLACE

41 41 41
318 718
400 800
100 200 100 100 200 200 200 100 100 200
385 400 400
15
131
22
Page
41 41
918
1000
200 200 200 100 100
400 200 400
BONNET CIDELCEM GRANDE CUISINE
Siége social:
Rue des Frères Lumière - Z.I Mitry Compans
77292 MITRY MORY Cedex
3BE390582NI – 06/07
41 41
1118
1200
200 200 200 200
400 400
41
902
200 100
385
15