Firm Plates; Gas Bratt Pan - Bonnet OPTIMUM 700 Builder’s Specifications

1.1 GAS BOILING PAN
The firm plates are fixed on the control board (see diagrams hereafter).
In any correspondence about your equipment, please indicate:
Firm plate
Rectangular boiling pans (250 litres) Round boiling pans (60, 110 et 150 litres)
Gas changing plate
A second plate is fixed near the nameplate,
which indicates:
- The gas for which the appliance has been
adjusted.
- The country of destination.
IN CASE OF A CHANGE OF GAS (See Section: Changing the appliance from one gas to another)
Modify this plate, and mention the new gas used.
Fill in the "Pays" zone with the name of the country where the appliance is installed.
NOTE: Both the Gas and Pressure for which the appliance is set must be authorised in the country in
question. Check this point in the section: Changing the appliance from one gas to another.
- The model number (Model.)
- The serial number (Fab.Nr.)
- The date (Date).
18
Page
1. FIRM PLATE
The box marked with a cross indicates the gas for which
Country of destination of the appliance
the appliance has been adjusted
BONNET CIDELCEM GRANDE CUISINE
Siége social:
Rue des Frères Lumière - Z.I Mitry Compans
77292 MITRY MORY Cedex
3BE390582NI – 06/07