Error Type
Bad Color
Incorrect position of needle
Change
stop
Failure to sense signals for
needle position or 1 rotation
Incorrect position of needle
bar
Incorrect position of take-up
lever
Fuse failure for color
change motor
Bad connection
Cause
Refer to user's manual
Run manual color change and
check if signal lamps (needle
set lamp & needle position
lamp) blinks at correct needle
position. Adjust the half-turn
film.
Set it to the correct position
Adjust so take-up lever is in line
with other levers in stop position
(upper shaft angle:100°)
Change fuse F3 in joint board
or check connection
Inspection & Repair
Reference
Set main shaft angle back at
100°, if you manually moved
it for cleaning, inspection or
repair.
Unscrew the lever and
adjust so it is in line with
the others on the guide
rail.
Thread take-
up driving
lever fixing
screw
Thread
take-up
Check fuse spec.