2.4.8 Busbar adapter
Busbar systems
Accessories
Measurements
SIRIUS System Manual
GWA 4NEB 430 0999-02b
2 3RV1 circuit breakers
To enable the circuit breakers to be mounted without using up too much
space, and to ensure that the infeed is economical in terms of both time and
money, the switches are mounted directly onto busbar systems using bus-
bar adapters.
The circuit breakers are snapped onto the adapter and connected at the
input side. This prepared unit is mounted directly onto the busbar systems,
thus both attaching it mechanically and establishing electrical contact.
The adapters are suitable for the following systems:
Busbar systems with
center-to-center spacing
40 mm systems
60 mm systems
Table 2-14: Busbar systems
The following accessories are available for busbar adapters:
• Modules that can be mounted on either side to widen the adapters
• Busbar holder for 3 rails
• Molded-plastic covers for 3 terminals (40 mm system)
• Molded-plastic cover profiles for shock protection
The following table lists the dimensions of the busbar adapters and accesso-
ries.
Busbar adapter and
System
accessories
40 mm
Circuit breaker
+ lateral auxiliary switch
Circuit breaker
Circuit breaker
Side module
60 mm
Circuit breaker
Side module
Table 2-15: Dimensions of the busbar adapters and accessories
For copper busbars in acc. with DIN 46 433
Width
12 mm and 15 mm
12 mm to 30 mm
Length
Width
121 mm
45 mm
55 mm
139 mm
55 mm
182 mm
70 mm
72 mm
139 mm
13.5 mm
182 mm
13.5 mm
182 mm
45 mm
182 mm
55 mm
182 mm
70 mm
72 mm
182 mm
13.5 mm
3RV1 circuit breakers
Depth
5 mm and 10 mm
5 mm and 10 mm
For circuit
breakers in frame
size
S00, S0
S2
S3 (up to 400 V)
S3 (up to 690 V)
S2
S3
S00, S0
S2
S3 (up to 400 V)
S3 (up to 690 V)
S00 to S3
2-37