Tech Controllers ST-976 User Manual page 18

MODE 1 – the user sets the temperature deviations for each day of the week separately
Configuring mode 1:
 Select: Set mode 1.
 Select the day of the week to be edited
 The following screen appears on the display
 Use
 Use
 The range of pre‐set temperature change is ‐10°C to 10°C.
 If you want to copy the temperature change value for the next hours, tap on
highlighted in red:
hour.
 Once all temperature changes for a given day are ready, select
 The display shows a screen enabling the user to copy the settings for the next day.
 If you want the CH boiler to operate according to these settings also on other days of the week,
select them and confirm by tapping on
 All settings may be deleted by selecting
Example:
If the pre‐set CH boiler temperature is 50°C, on Mondays between 4
to reach 55°C; between 7
reach 57°C.
18
to select the hour to be edited
to increase or decrease the corresponding temperature value as needed
Then, use
Hour
00
4
00
7
PRE‐SET
00
17
00 00
and 14 it will drop by 10°C, to reach 40°C, and between 17
to copy the settings into the previous or the following
.
and confirming it.
Temperature ‐ weekly control
setting (+/‐)
Monday
00
‐ 7
00
‐ 14
00
‐ 22
‐ it will be
.
+5°C
‐10°C
+7°C
00 00
and 7 the CH boiler will increase by 5°C
00 00
and 22 it will increase to