Slave Address For Ics (8Bits) List; Error Code List - Omron STC-HD213 Series Product Specifications And User's Manual

Slave address for ICs (8bits) list

IC
DSP
EEPROM
EEPROM
EEPROM
EEPROM
EEPROM
EEPROM
EEPROM
EEPROM
EEPROM
uCOM
EEPROM
Note: There is maximum number of writing to EEPROM of 1,000,000 times.

Error code list

If an error occurs, camera sends an error code with following format:
The Command number of Error Message is FF (HEX). The Data length is 0002.
Error
Last data that camera was received was not ETX (0x03)
Check sum does NOT match data being transmitted
The command being transmitted does NOT exist or is invalid
Unprocessed data remains in receiving buffer
Time out
Over run error
Data length error (too long)
I2C communication error
Note.1: The camera disregards data, which is not start with STX (0x02).
Note.2: The time out error is occurred when camera does not receive next data 3 seconds after receiving
data.
STC-HD213DV / STC-HD213DV-CS / STC-HD213SDI / STC-HD213SDI-CS /
STC-HD213DVN / STC-HD213DVN-CS / STC-HD213SDIN / STC-HD213SDIN-CS
Product Specifications and User's Guide
Slave Address
82 DSP data
62 The Virtual EEPROM zone for currently selected DSP preset
mode of Preset 0 to Preset 7
90 The EEPROM zone for Preset 0 DSP data
91 The EEPROM zone for Preset 1 DSP data
92 The EEPROM zone for Preset 2 DSP data
93 The EEPROM zone for Preset 3 DSP data
94 The EEPROM zone for Preset 4 DSP data
95 The EEPROM zone for Preset 5 DSP data
96 The EEPROM zone for Preset 6 DSP data
97 The EEPROM zone for Preset 7 DSP data
22 The uCOM data
42 The EEPROM zone for uCOM Data
詳細
Receive data
02, FF, 00, 02, 02, 00, 03, 03
02, FF, 00, 02, 03, 00, 04, 03
02, FF, 00, 02, 04, 00, 05, 03
02, FF, 00, 02, 05, 00, 06, 03
02, FF, 00, 02, 06, 00, 07, 03
02, FF, 00, 02, 08, 00, 08, 03
02, FF, 00, 02, 0B, 00, 0C, 03
02, FF, 00, 02, 10, 00, 11, 03
No. 20S071-01
69/94