Equipment Delivery And Handling; Factory Shipment; Receipt Of Shipment; Storage - Siemens 353 User Manual

Introduction

1.4 EQUIPMENT DELIVERY AND HANDLING

1.4.1 Factory Shipment

Prior to shipment, a controller is fully tested and inspected to ensure proper operation. It is then packaged for
shipment. Most accessories are shipped separately. Shown below are some of the items shipped with a controller.
Actual items included in a shipment will depend upon controller model number. A printed copy of the 353
Installation Guide, IG353-1 is also supplied.
Range
Resistors
Crimp on
Connectors
Literature CD

1.4.2 Receipt of Shipment

Inspect each carton at the time of delivery for possible external damage. Any visible damage should be immediately
recorded on the carrier's copy of the delivery slip.
Carefully unpack each carton and check the contents against the enclosed packing list. Inspect each item for any
hidden damage that may or may not have been accompanied by exterior carton damage.
If it is found that some items have been damaged or are missing, notify the Process Instrumentation Division of
Siemens Energy and Automation immediately and provide full details. In addition, damages must be reported to the
carrier with a request for their on-site inspection of the damaged item and its shipping carton.

1.4.3 Storage

If a controller is to be stored for a period prior to installation, review the environmental specifications in Section 13
Model Designation and Specifications.

1.4.4 Typical Shipment Contents

The items listed below are those typically included in a shipment and are subject to change.
1. Siemens 353 Process Automation Controller, model number per order, qty. 1
2. MMC or MMCplus™ memory card (inserted in MMC socket on MPU Controller board), qty 1
3. Power Input and Range Resistor Kit, PN 16354-30, qty. 1
1-8
Case Rear
Terminals
Rear
Terminal
Cover
Case Mounting
Clips
UM353-1B
April 2012