Start-Up Checklist - Modine Manufacturing DBS Installation And Service Manual

Indirect gas-fired indoor separated combustion make-up air units
Table of Contents

Advertisement

START-UP CHECKLIST

START-UP CHECKLIST
INDIRECT GAS-FIRED HEATING EQUIPMENT
Job Name:
Address:
City & State:
Start-Up Check List "ALL ITEMS MUST BE CHECKED"
1. All shipping straps, braces, tie downs removed?
2. Unit installed level and secure?
3. Gas burner properly located and aligned?
4. Blower and motor alignment okay?
5. Bearings aligned and tight on shaft/bearing supports?
6. Electrical connections checked and secure?
7. Gas piping checked and tightened if necessary?
8. Any visible damage to unit?
Describe: ______________________________________________
If damaged, was the damage repaired?
9. Air inlet and discharge checked for obstructions?
10. Bearings checked for proper lubrication?
11. Filters in place and correct to direction of air flow?
12. Belt tension checked?
13. Electric supply to unit: ______ Volts, ______ Hz, ______ Phase
14. Gas supply to unit: ______ Natural, ______ Propane
15. Gas supply pressure to unit: ______ " W.C., ______ PSIG
16. Inlet and/or discharge dampers operating correctly?
17. Blower rotation correct?
18. Blower speed: Hi Speed ______ RPM, Lo Speed ______ RPM
19. Motor speed: Hi Speed ______ RPM, Lo Speed ______ RPM
20. Is unit noisy? Excessive vibration?
21. Motor voltage: L1 ______ V, L2 ______ V, L3 ______ V
22. Motor amps: L1 ______ Amp, L2 ______ Amp, L3 ______ Amp
23. High temperature limit control continuity checked?
24. Burner light off
Low Fire: Does entire burner light off?
Hi Fire: Burner pressure reading? ______ " W.C.
Is flame clean and stable?
Does flame modulate in response to temperature control(s)?
25. Gas input checked?
Input at maximum firing rate: __________ Btu/Hr
Input at minimum firing rate: -__________ Btu/Hr
26. Gas piping checked for and free of leaks?
27. Has wiring been verified to match the unit wiring diagram?
28. Have all the modes of the sequence of operation been verified and tested?
29. What optional and/or accessory control devices have been set?
Device: _______________ Setting: ___________ (°F/psi/Inches W.C./etc.)
Device: _______________ Setting: ___________ (°F/psi/Inches W.C./etc.)
Device: _______________ Setting: ___________ (°F/psi/Inches W.C./etc.)
Customer/Owner instructed in operation and maintenance of unit?
Name of Person(s) Instructed: ______________________________________________________________
Comments: ____________________________________________________________________________
____________________________________________________________________________
Start-Up Company Name: _______________________________ Phone: __________________________
Signature: _______________________________________________________ Date: ________________
Date:
Model No.:
Order No.:
Serial No.:
5-594.10
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
____ Yes
___ No
55

Advertisement

Table of Contents
loading

This manual is also suitable for:

DcsIbsIcs

Table of Contents