Function Buttons Description - WilTec 50039 Operation Manual

When the chicks are hatched, you will need to ensure that they cannot drown, whilst poten-
tially still breeding chicks still need to hatch.
Display, function buttons and basic settings
For incubators with item no. 50039, 50041, 51077, 51271, 51272, 51273, 51274
The connection for the electricity plug is on the left outer corner of the control panel.
On the right outer corner, there is the on/off switch. It is important that the electricity plug is completely
plugged in before operating the on/off switch. If the on/off switch is glowing, the incubator is switched
on and ready for use.
Besides the four displays (1–4), there are four more buttons which the incubator is operated by (see
"Function buttons description") and two small lamps that glow while the heater is heating ("work")
or when adjustments are being made ("set").
Display 1 shows the turning frequency in [hours:minutes].
Display 2 shows the temperature in degrees Celsius.
Display 3 shows the day.
Display 4 shows the humidity percentage.

Function buttons description

For the incubators with item no. 50039, 50041, 51077, 51271, 51272, 51273, 51274
These incubators have four buttons that are required for operation. The buttons and their combination
possibilities will be further described in the following. Before turning the on switch on, ensure that the
plug is undamaged and connected properly with the according place.
The buttons are positioned as follows from left to right (green and round) in the centre of the operating
panel: "rst" (reset), "set", "+" and "–".
1. Rst (Reset): This button allows for the turning to be carried out manually.
Push the buttons once shortly: The device will turn the eggs for the time set in display.

After that, the counter will reset itself to the adjusted time (in this case 2 hours) and
will turn the eggs again after 2 hours.
The turning frequency can be adjusted, see table 1 further below.

Set: This button allows for the setting of the required incubator conditions.

Push the button once shortly: Adjustment of the basic temperature (parameter ID:

PP).
© by WilTec Wildanger Technik GmbH Item 50039, 50041, 51074–51077, 51271–51274
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Page 9
11 2020-1