WilTec 50039 Operation Manual page 8

3. Check the individual values by means of an additional thermometer and hygrometer. If neces-
sary, calibrate the values. Test how to keep the desired air humidity at the right level/how
much water is required to stay in the desired range.
4. If the incubator works without a problem, and you are accustomed with the functions, unplug
the incubator and clean it from the inside and the outside with a suitable disinfectant.
Adding the Eggs
1. As soon as the incubator has been cleaned, water can be filled into the incubator grooves.
Please note, that the humidity needs to be lower at the beginning of the breeding process and
higher towards the end. Thus, only fill a little bit of water into the grooves at the beginning. The
incubator has a small hole on the side (see fig. 3), through which some water can be added if
required (too low humidity). This allows for the lid to stay closed during the breeding.
Fig 3: Opening for water refill
1. After having adjusted the desired incubator parameters, the eggs can be placed into the des-
ignated insert. Please ensure to place the tip of the egg downwards and that the day display
marks 0.
2. Frequently check the incubator temperature and humidity on the control panel, and if required,
alter them. Also be aware of the water level inside the grooves; they should always be effi-
ciently filled.
Important: The insert should not be wet! Otherwise, the hatching results can be negatively im-
pacted!
3. Towards the end of the breeding process, the eggs must not be turned any more. The auto-
matic turning mechanism then needs to be switched off. Thus, either switch the turning fre-
quency or turning duration to 0; it is also possible to put both onto 0 (please see section "Dis-
play, function buttons and basic settings").
Alternatively, the electrical connection between the turning motor and the lid can be interrup-
ted by separating the cables.
It is also possible to remove the turning mechanism entirely by opening the incubator, separat-
ing both turning motor cables and lifting the turning mechanism out of the incubator. After -
wards, the eggs can be carefully placed back onto the wire insert. Spray the eggs with warm
water and store the eggs carefully, yet quickly, so that the humid, warm climate is preserved.
Important: Please note that the incubator should not be opened towards the end with more
sensitive types of birds; therefore it is recommended not to manually disconnect the electricity
supply to the turning motor but to just change the settings accordingly.
4. If the turning function has been switched off and the eggs are not being moved any more, it is
important to keep the humidity high. During the hatching process, the lid should remain
closed. Water can be added with a jug to avoid the eggshells from drying out.
© by WilTec Wildanger Technik GmbH Item 50039, 50041, 51074–51077, 51271–51274
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Note: Please regard the individual require-
ments of each animal species. Do not fill too
much water into the incubator, as it is difficult
to remove it once the breeding has begun, and
can lead to a negative hatching result. Ideally,
you have already at the beginning found out
how much water needs to be filled in.
Note: If the humidity is too low, even though
both groves are filled with plenty of water, addi-
tional containers with water can be placed into
the incubator. Please assure that neither the
eggs nor the holders get wet. Do not let the in-
cubator stand open for too long when placing
the containers, as this can have a negative im-
pact on the hatching results.
Page 8
11 2020-1