WilTec 50039 Operation Manual page 14

Function buttons explanation
For the incubator with item no. 51076
The incubator has three buttons which are required for the operation of the incubator. The buttons and
their possible combinations will be explained in the following paragraph. Before putting the incubator
on by the on/off switch, ensure that the plug is properly plugged into the according area.
The buttons are positioned the following from left to right (green and round) in the centre of the operat-
ing panel: "set", "+" and "–".
1. Set: This button allows to set the basic temperature of the incubator.
Push the button once shortly: Adjustment of the basic temperature (parameter ID:

PP).
By activating the "+" and "–" buttons, the desired temperature can be adjusted, an-

other "set" button push allows the entered value to be saved.
Keeping the "set" button pushed: This will lead you into the menu to adjust the basic

parameter (see table 5).
By activating the "set" button again, the various parameters can be selected.

If you wish to alter a parameter, push the "+" and "–" button to adjust the value shown

upwards or downward. By pushing the "set" button again, the value is saved.
Display 2 will show each parameter via a number/letter combination (parameter ID).

Display 1 will show the changeable data.

Basic parameter
Turning frequency
Turning duration
Temperature calibration
Humidity calibration
Display of days
Table 5: Adjusting the basic parameters via the "set" buttons
1. Holding down "set" and "+" together at the same time will open the menu for finer para -
meter adjustments (see table 6)
By pushing the "set" button again, each parameter can be seen.

If you wish to alter a parameter, push the "+" and "–" buttons, to alter the value up-

wards or downward. By activating the "set" button again, the data is saved.
Display 2 shows the individual parameter, which is shown in a number/letter combina-

tion (parameter ID).
Display 1 shows the changeable value.

Finer parameters
Temperature alarm
too high
Heating stop
© by WilTec Wildanger Technik GmbH Item 50039, 50041, 51074–51077, 51271–51274
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Parameter Adjustment range
ID
F1 0–999 min
F2 0–999 sec
F3 According to thermometer
F4 According to humidity sensor
F5 0–99
Parameter Adjustment range
ID
P1 0–99.9°C
P2 0–99.9°C
Standard Note
setting
120 min When selecting
0 minutes, there
will be no turn-
ing
15 sec When selecting
0 minutes, there
will be no more
turning
Remember to set the display of
days after every breeding back
to 0. The incubator will not do it
automatically.
Standard Note
setting
38.6°C
37.8°C Please note that the
radiator will switch
off when reaching
Page 14
11 2020-1