Advertisement
Quick Links
Operation Manual
Incubator for Reptile Eggs
52168, 52169
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps, and technical data can differ insignificantly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Related Manuals for WilTec 52168
Summary of Contents for WilTec 52168
- Page 1 Operation Manual Incubator for Reptile Eggs 52168, 52169 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps, and technical data can differ insignificantly.
- Page 2 All rights re- served. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 ±3 % RH Adjustable temperature regulation Hygrometer to measure humidity Functions Temperature display Humidity display Day number display Power supply 230 V / 50 Hz © by WilTec Wildanger Technik GmbH Item 52168, 52169 Page 3 http://www.WilTec.de http://www.aoyue.eu 2022-1 http://www.teichtip.de...
-
Page 4: Surrounding Conditions
Max. egg number • 52168: up to approx. 32 eggs (depending on clutch type) • 52169: up to approx. 48 eggs (depending on clutch type) General notes • This incubator allows you to maintain a constant temperature that will enable you to successfully hatch a wide variety of reptile eggs. - Page 5 To reduce the humidity, decrease the water surface by using smaller containers. Important: Choose the shape and design of the water containers keeping in mind that they should not be fatally dangerous for the hatched reptiles. © by WilTec Wildanger Technik GmbH Item 52168, 52169 Page 5 http://www.WilTec.de...
- Page 6 If the incubator works without a problem, and you are accustomed with the functions, unplug the incubator and clean it on the inside and the outside with a suitable disinfectant. © by WilTec Wildanger Technik GmbH Item 52168, 52169 Page 6 http://www.WilTec.de...
- Page 7 From the upper part on the left to the lower part on the right, there are the following function buttons: • 4: “Set” • 5: “Up” / “+” • 6: “On/off” • 7: “Reset” • 8: “Down” / “–” © by WilTec Wildanger Technik GmbH Item 52168, 52169 Page 7 http://www.WilTec.de http://www.aoyue.eu 2022-1 http://www.teichtip.de...
- Page 8 3. “Reset” button: will reset all values to factory settings; you will hear a beeping sound. This is the only possibility to reset the number of the days to 0. © by WilTec Wildanger Technik GmbH Item 52168, 52169 Page 8 http://www.WilTec.de...
- Page 9 Temperature sensor broken Exchange sensor. but only same letter When turning incu- bator fuse Short circuit due to defective vent Replace incubator. blows every time © by WilTec Wildanger Technik GmbH Item 52168, 52169 Page 9 http://www.WilTec.de http://www.aoyue.eu 2022-1 http://www.teichtip.de...
- Page 10 This logo indicates that this electric equipment must not be disposed with the domestic waste. The company WilTec Technik GmbH has been registered in the German registry EAR under the WEEE- registration number DE45283704. Disposal of used electrical and electronic appliances...