WilTec 50039 Operation Manual page 15

Heating start
Temperature alarm
too low
Humidity alarm too
high
Humidity alarm too
low
Table 6: Adjustment of the finer parameters via the "set" and "+" buttons
"+" : Allows for the turning to be carried out manually.

Push the buttons once shortly: The device will turn the eggs for the time set in dis-
play 1. After that, the counter will reset itself to the adjusted time (in this case 2 hours)
and will turn the eggs again after 2 hours.
The turning frequency can be adjusted, see table further up.
"+" and "–": Holding both down at the same for a longer moment (approx. 8 seconds)

will reset the incubator to factory settings; a beep will sound.
© by WilTec Wildanger Technik GmbH Item 50039, 50041, 51074–51077, 51271–51274
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
P3 0–99.9°C
P4 0–99.9°C
H1 0–99%
H2 0–99%
the entered value,
but will still radiate
some warmth, and
the
might still rise a little
bit in the incubator.
This
that a temperature
of 38°C
reached when set-
ting the temperature
to 37.8°C. If you
wish to avoid this,
the heating
temperature
to be
downwards.
37.5°C
37°C
80%
40%
temperature
means e. g.
can be
stop
needs
corrected
Page 15
11 2020-1