WilTec 50039 Operation Manual page 10

By activating the "+" and "–" buttons, the desired temperature can be adjusted, an-

other "set" button push allows the entered value to be saved.
Keeping the "set" button pushed: This will lead you into the menu to adjust the basic

parameter (see table 1).
By activating the "set" button again, the various parameters can be selected.

If you wish to alter a parameter, push the "+" and "–" button to adjust the value shown

upwards or downward. By pushing the "set" button again, the value is saved.
Display 4 will show each parameter via a number/letter combination (parameter ID).

Display 2 will show the changeable data.

Basic parameters
Turning frequency
Turning duration
Temperature calibration
Humidity calibration
Display of days
Table 1: Adjustment of the basic parameters via the "set" button
Holding "set "and "+" at the same time will let you enter the menu for fine adjustments (see

table 2).
By activating the "set" button again, the various parameters can be selected.

If you wish to alter a parameter, push the "+" and "–" button to adjust the value shown

upwards or downward. By pushing the "set" button again, the value is saved.
Display 4 will show each parameter via a number/letter combination (parameter ID).

Display 2 will show the changeable data.

Finer parameters
Temperature alarm
too high
Heating stop
© by WilTec Wildanger Technik GmbH Item 50039, 50041, 51074–51077, 51271–51274
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Parameter- Adjustment range
ID
F1 0–999 min
F2 0–999 sec
F3 According to thermometer
F4 According to hygrometer
F5 0–99
Parameter Adjustment range
ID
P1 0–99.9°C
P2 0–99.9°C
Standard Note
value
120 min When selecting
0 minutes, there
will be no turn-
ing
15 sec When selecting
0 minutes, there
will be no more
turning
Remember to set the display of
days after every breeding back
to 0. The incubator will not do it
automatically.
Standard Note
setting
38.5°C
37.7°C Please note that the
radiator will switch
off when reaching
the value entered,
but will still radiate
some warmth, and
the
might still rise a little
bit inside the incub-
ator, which means
e. g. that a temper-
ature of 38°C can be
reached when set-
ting the temperature
to 37.8°C. If you
wish to avoid this,
the heating
temperature
temperature
stop
needs
Page 10
11 2020-1