WilTec 50039 Operation Manual page 11

Heating start
Temperature alarm
too low
Humidity alarm too
high
Humidity alarm too
low
Table 2: Adjustment of the finer parameters via the "set" button
"+" and "–": Holding both down at the same for a longer moment (approx. 8 seconds) will

reset the incubator to factory settings, a beep will sound.
Display, function buttons and basic parameters
For the incubators with item no. 51074, 51075
On the control panel left outer corner, there is the connection for the electricity plug. It is important to
push the plug in well to allow for the proper operation of the incubator. As soon as the plug is connec -
ted, the incubator will turn on.
Besides the two display (1 and 2), there are three buttons with which the device is operated (see "De-
scription of the function buttons") and two small lights that will glow when the heater is heating
("work") or adjustments are made to the settings ("set").
Display 1 shows the temperature in Celsius.
Display 2 shows the humidity percentag.
© by WilTec Wildanger Technik GmbH Item 50039, 50041, 51074–51077, 51271–51274
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
P3 0–99.9°C
P4 0–99.9°C
H1 0–99%
H2 0–99%
to be
downwards.
37.4°C
36.9°C
80%
40%
corrected
Page 11
11 2020-1