Multiple Failures In The Same Array; Resetting The Controller - Adaptec ICP5045BL User Manual

Multiple Failures in the Same Array

Except in RAID 6 and RAID 60 arrays (see
same time in the same array, the data can't be recovered.
Correct the cause of the failure or replace the failed disk drives. Then, restore your data (if
available).
Note:
In some instances, RAID 10 and RAID 50 arrays may survive multiple disk drive failures,
depending on which disk drives fail. For more information, refer to the ICP Storage Manager
User's Guide or online Help.

Resetting the Controller

This section explains how to reset (or flash) your ICP RAID controller. You may want to do this
if the controller becomes inoperable, or if a firmware upgrade is unsuccessful.
To reset your ICP RAID controller:
Download the firmware version currently installed on your controller from
1
vortex.com
Extract the downloaded files to a folder on your local hard drive (for example,
2
C:\Download\Drivers).
Create a bootable MS–DOS floppy disk and copy the IFU.exe file to it. Copy the first
3
firmware image to the same floppy disk.
Create additional bootable MS–DOS floppy disks and copy each additional firmware
4
image to its own floppy disk.
Power off your computer, disconnect the power cord, then open the cabinet following the
5
manufacturer's instructions.
Disconnect all cables from the controller, then attach a shorting jumper to the Mode 0
6
flash connector. (To locate the Mode 0 flash connector on your ICP RAID controller, see
the figures in
Reconnect the power cord, power on your computer, then boot to the floppy disk
7
containing the IFU.exe file (see
At the prompt, type
8
where is the controller number.
x
Insert the other floppy disks when prompted.
9
When the flash is complete, power off your computer, disconnect the power cord, then
10
remove the jumper.
Close the computer cabinet, reconnect the power cord, then power on your computer.
11
The controller should boot correctly.
page
About Your RAID Controller on page
Step 3).
a: \ifu update /c x
Chapter 10: Solving Problems
74), if more than one disk drive fails at the
15.)
66
●
www.icp-