Epsonnet Config (Web Version); Starting Epsonnet Config (Web Version) - Epson TM-P80 Technical Reference Manual

EpsonNet Config (Web Version)

EpsonNet Config (Web version) is a utility to configure the network and other settings on a web browser.

Starting EpsonNet Config (Web Version)

Follow the steps below to start up EpsonNet Config (web version).
1
Start up a PC connected to the network.
2
Start up the web browser and input the printer's IP address (http://printer's IP
address) in the address bar as shown below.
• You can check the printer's IP address using the dynamic status sheet or in self-test mode. For
• In the initial setting, the user name and password will be required on the authentication
68
http://xxx.xxx.xxx.xxx
details on printing the dynamic status sheet, see
66. For details on the self-test mode, see
screen when you access EpsonNet Config (web version) from a browser. The settings for the
user name and password are as follows. The default setting for the password varies depending
on the Wi-Fi model's firmware version.
Wi-Fi model's
User name
firmware version
Before 1.30 "epson"
1.30 or later "epson"
You can check the Wi-Fi model's firmware version using the self-test.
57)
You can check the product's serial number using a self-test or on the manufacturing
nameplate attached to the product.
You can change the password in [Password] in the Optional configuration menu.
"Dynamic Status Sheet Print Mode" on page
"Self-test mode" on page 57.
Password
"epson"
Product serial number (10 alphanumeric characters,
case sensitive)
("Self-test mode" on page 57)
("Self-test mode" on page