Epson TM-P80 Technical Reference Manual page 63

Bluetooth Security Settings (Bluetooth)
When the firmware version is 1.02 ESC/POS or later, you can change the Bluetooth security settings. (iOS Blue-
tooth model only)
When the security settings are changed, the link key (pairing information) is removed.
You can also change the settings using the printer Utility and TM Utility for iOS/Android.
In Bluetooth model, select 2: Bluetooth, and then select 3: Security, and you can change the security settings.
Security
Low
Middle
High
* When Middle or High is selected, the power LED flashes in the following pattern while pairing is possible.
Pairing method when the security is set to Middle/High (from the printer)
When the security is set to Middle or High and the printer is ready to be paired, perform the following proce-
dure.
1
Load paper in the printer, and then turn it on.
Make sure no errors have occurred and that the printer is not off-line.
2
Open the roll paper cover, hold down the FEED button (two seconds), and when the
buzzer sounds, close the roll paper cover.
3
A status sheet is printed, and the power LED flashes a pattern indicating that pairing
is now possible.
Pairing is possible for one minute after printing the status sheet.
Pairing Mode
Pairing is always possible
Pairing is possible for one minute after
printing the status sheet
Pairing is possible for one minute after
printing the status sheet
5,120 ms
Approx. 640 ms
Chapter 3 Advanced Usage
Pairing Method
Just Works
Just Works
Numeric Comparison/Passkey Entry
3
63