Land Pride OS1548 Operator's Manual page 53

Section 4: Maintenance & Lubrication
Type B Clutch
Clutch Run-In
Refer to Figure 4-10:
1. Loosen counterclockwise all 8 hex head socket bolts
uniformly 6 full turns.
2. Cycle clutch on and off 5 or 6 times (15 seconds on
and 15 seconds off) with the engine operating at half
throttle. Disengage power take-off, shut off tractor,
and remove key. Wait for all components to stop
before dismounting from tractor.
3. Tighten hex head socket bolts fully back. Clutch is
ready for use
4. The clutch should be checked during the first hour of
cutting and periodically each week.
Hex Head
Socket Bolts
Type B Clutch Run-In
Figure 4-10
Disassembly and Assembly
Refer to Figure 4-11:
If the clutch run-in procedure indicated that one or more of
the friction disks did not slip, then the clutch must be
disassembled to separate the friction disks.
1. Rotate 8 hex head socket bolts (#2) all the way out to
free stop flange (#3).
2. Rotate stop flange (#3) and remove from
housing (#11)
3. Remove the following inner components:
a. Spring kit (#4)
b. Pressure flange (#5)
c. 1st Friction Disc (#6)
d. Hub with flange and pull collar (#7 & #1)
e. 2nd Friction disc (#6)
f. Intermediate flange (#8)
g. 3rd Friction disc (#6)
h. Hub disc (#9)
i. 4th Friction disc (#6)
j. Bearing (#10)
4. Inspect all components and replace to their original
position. Make certain stop flange (#3) is replaced
with its flanges down as shown.
5. Fully tighten all 8 hex head socket bolts (#2).
11/28/18
Table of Contents
(IMPORTANT NOTICE)
Check position of lip on stop
flange (UP or DOWN).
Replace stop flange with lip in
its original position.
21270
22376
OS1548 and OS1572 Overseeder (S/N 166724+) 308-303M
Type B Clutch Assembly
Figure 4-11
49