Land Pride OS1548 Operator's Manual page 19

Section 1: Assembly & Set-up
37298
Always engage power take-off at low engine rpm to
minimize driveline start-up torque. Drivelines with
friction clutches must go through a "run-in"
operation prior to initial use and after long periods of
inactivity. See "Driveline Slip Clutches" on page 46.
If the Overseeder is used on more than one tractor, an
additional driveline may be required - especially if a
Quick Hitch is used.
!
DANGER
To avoid serious injury or death:
• Do not engage power take-off while hooking-up or
unhooking the driveline, or while someone is standing near
the driveline. A person's body and/or clothing can become
entangled in the driveline.
Tractor power take-off shaft shield, driveline shields, and
•
gearbox shaft shields must be installed and in good working
condition to avoid driveline entanglement and projectiles
flying off of the driveline.
• Do not use a power take-off adapter. The adapter will
increase strain on the tractor's power take-off shaft causing
possible damage to shaft and driveline. It will also defeat
the purpose of the tractor's power take-off shield.
!
WARNING
To avoid serious injury or death:
Always shut tractor down using "Tractor Shutdown
Procedure" provided in this manual before dismounting
tractor.
!
CAUTION
To avoid minor or moderate injury: Some tractors are
equipped with two power take-off speeds. Do not exceed 540
rpm power take-off speed or equipment breakage may result.
11/28/18
Table of Contents
Tractor Hook-Up
Figure 1-11
IMPORTANT: An additional driveline may be
required if implement will be attached to more than
one tractor.
22235
Pull Collar Coupling (#9)
22234
OS1548 and OS1572 Overseeder (S/N 166724+) 308-303M
Implement End
Pull Collar Coupler (#8)
Slip Clutch Protection
Tractor End
Figure 1-12
Implement End
Push Pin Coupling (#10)
Pull Collar Coupler (#8)
Slip Clutch Protection
Tractor End
Figure 1-13
70128
33047
With
With
15