Land Pride OS1548 Operator's Manual page 22

Section 1: Assembly & Set-up
37298
Hook-up LED Lights
Refer to Figure 1-17:
The lead wiring harness (#11) is equipped with a
7-way round pin connector for connecting to the tractor's
7-pin electrical outlet shown in Figure 1-18.
1. Route lead wire harness (#11) to the tractor.
2. Connect wire harness (#11) to the tractor's 7-way
round pin receiver. See Figure 1-18.
3. It is best to have a second person verify the lights are
operating. Start tractor and operate lights as follows:
a. Turn on head lights to verify red lights illuminate.
b. Turn on flasher lights to verify amber light are
blinking on and off.
4. If lights did not operate properly, check all electrical
connections on the wire harness (See Figure 1-19).
Yellow and red wires with same pin letters should
match at the connections. Make necessary changes
and repeat step 3 above.
5. Check wire harness routing to make sure wires will
not be pinched while raising and lowering the seeder.
18
OS1548 and OS1572 Overseeder (S/N 166724+) 308-303M
Table of Contents
LED Light Hook-Up
Figure 1-17
Tractor 7-Pin Electrical Outlet
Figure 1-18
Electrical Connector Pin Letters
Figure 1-19
70128
33047
11/28/18