Land Pride OS1548 Operator's Manual page 17

Section 1: Assembly & Set-up
16. Position hub inside bearing mount against bearing seal and
tighten set screws.
17. Add grease to right-hand bearing by using grease zerk
located on the right-hand bearing cover.
18. Reassemble gauge wheel & drive chains. Reattach chain
guard.
Rear Roller Assembly
Refer to Figure 1-6:
1. Attach packer wheel assembly (#2) to Overseeder frame
using 1" x 3 11/16" long clevis pins (#5), flat washers (#3), and
3/16" x 1 3/4" cotter pins (#4).
2. If Overseeder has a rear roller drive, skip to "Rear Roller
Drive (Optional)" below.
3. Attach support chains (#1) to Overseeder frame and to
packer wheel arms using 5/16" utility clevises (#6) and clevis
pins (#7). Tighten clevis pins.
Gauge Wheel Drive (Optional)
Refer to Figure 1-7:
1. Remove locknut (#11) and bolt (#12). Rotate gauge wheel
arm (#2) down.
2. Bolt drive spindle & hub (#1) to gauge wheel arm (#2) with
5/16" x 1 1/2" bolts (#3) and 5/16" locknuts (#4).
3. Rotate gauge wheel arm (#2) up and bolt to turnbuckle (#13)
with removed bolt (#12) and locknut (#11). Draw locknut up
snug, do not tighten.
4. Attach wheel (#5) to hub (#1) with 1/2" x 1 3/8" lug bolts (#6)
and lug nuts (#7). Repeat steps 1 to 3 for the left-hand side,
except use non-drive spindle and hub (#8) with bolts (#6).
IMPORTANT: Roller chains must be installed on the seeder
at the correct gear ratio. Refer to "Speed Change Sprocket"
starting on page 22 to determine correct chain installation.
5. Bolt chain guard (#9) to the right-hand frame end plate using
1/4" x 1/2" long bolts (#10).
Rear Roller Drive (Optional)
Refer to Figure 1-8:
1. Attach solid links (#1) to back of frame with 5/8" x 2 3/4" long
bolts (#2) on top and 5/8" x 1 3/4" bolts (#4) on the bottom.
IMPORTANT: Roller chains must be installed on the seeder
at the correct gear ratio. Refer to "Speed Change Sprocket"
starting on page 22 to determine correct chain installation.
2. Bolt chain guard (#9) to end plate using 5/16" x 6" bolt (#10),
5/16" lock washer (#11), and 1/4" x 1/2" bolts (#12).
NOTE: See "Rear Arm Length Adjustment" on page 32 for
definition of long arm and short arm.
3. If rear roller (#13) is in the short arm position as shown,
attach front chain guard (#7) and rear chain guard (#6) with
5/16" x 2 1/2" bolts (#8) in the locations shown.
11/28/18
Table of Contents
OS1548 and OS1572 Overseeder (S/N 166724+) 308-303M
Rear Roller Installation
Figure 1-6
Gauge Wheel Drive Assembly
Figure 1-7
Rear Roller Drive Assembly with Short Arm
Figure 1-8
14599
14598
14601
13