Copyright 2002 All rights Reserved Land Pride provides this publication “as is” without warranty of any kind, either expressed or implied. While every precaution has been taken in the preparation of this manual, Land Pride assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of the information contained herein. Land Pride reserves the right to revise and improve its products as it sees fit.
“Safety Label” section, read all engine, and remove the key. instructions noted on them. Detach and store implements in a area where children normally do not play. Secure implement by using blocks and supports. 6/26/02 SPS20 & SPS30 Series Pulverizer Seeders 313-242M...
Page 4
Allow implement to cool Remove buildup of grease, oil or completely. debris. Do not grease or oil implement Remove all tools and unused while it is in operation. parts from implement before operation. SPS20 & SPS30 Series Pulverizer Seeders 313-242M 6/26/02...
Page 5
Keep hands and feet on controls away from power-driven parts. or footrests. Never lean out the Wear snug fitting clothing to avoid front of the cab with the engine entanglement with moving parts. running. 6/26/02 SPS20 & SPS30 Series Pulverizer Seeders 313-242M...
Safety Labels the correct safety labels are included in the request. To order new labels go to your Land Pride dealer. 1. Your pulverizer seeder comes equipped with all safety labels 5. Refer to this section for proper label placement.
The SPS2048 and SPS3072 Pulverizer Seeders are designed and should only be replaced with genuine Land designed and built by Land Pride to efficiently do the tasks Pride parts. Therefore, should your pulverizer require of seedbed preparation and precision seeding. Both the replacement parts go to your Land Pride Dealer.
The gauge wheels are disassembled during shipping. the desired height. They will need to be unbanded from the crate and 2. Secure with pin (#4). reassembled. 18547 Dealer Gauge Wheel Assembly Figure 1-1 SPS20 & SPS30 Series Pulverizer Seeders 313-242M 6/26/02...
2. Secure the tractor’s 3-Point lower links to the lower hitch clevises using 7/8” diameter hitch pins on the 3. When traveling over rough or hilly terrain, shift tractor SPS3072 and secure to the lower hitch pins on the 6/26/02 SPS20 & SPS30 Series Pulverizer Seeders 313-242M...
You can increase Prior to putting your Land Pride Pulverizer Seeder into your speed when you are confident that you are achieving service you must thoroughly review the Operator’s the desired results.
5. You may want to repeat the calibration procedure if the results of your calibration vary greatly from the Speed Change & Chain Pitches suggested settings on the chart. Figure 3-1 6/26/02 SPS20 & SPS30 Series Pulverizer Seeders 313-242M...
DO NOT open the cup to the wide open position with seed in the box unless complete clean out is desired. 18494 Down Pressure Adjustment Figure 3-3 18494 Seed Rate Handle Figure 3-2 SPS20 & SPS30 Series Pulverizer Seeders 313-242M 6/26/02...
The Clutch can be engaged by turning the pin until the pin slides in the groove. Disengage by pulling out on the pin and turning it until it is out of the groove. (Engaged for seeding.) Clutch Engagement 18492 Figure 3-6 6/26/02 SPS20 & SPS30 Series Pulverizer Seeders 313-242M...
Low Range Lovegrass - Sand (Pounds per 1000 Square Feet) High Range 10.2 11.4 12.6 13.7 14.9 16.1 17.3 18.4 19.6 21.3 22.5 23.7 24.9 Low Range Lovegrass - Weeping (Pounds per Acre) SPS20 & SPS30 Series Pulverizer Seeders 313-242M 6/26/02...
Page 19
Wheatgrass - Crested (Pounds per 1000 Square Feet) High Range Low Range Wheatgrass - Western (Pounds per Acre) High Range Low Range Wheatgrass - Western (Pounds per 1000 Square Feet) High Range Low Range 6/26/02 SPS20 & SPS30 Series Pulverizer Seeders 313-242M...
Lovegrass - Sand (Kilograms per 1000 Square Meters) High Range Low Range Lovegrass - Weeping (Kilograms per Hectare) High Range 971 1030 1089 1148 1206 1268 Low Range Lovegrass - Weeping (Kilograms per 1000 Square Meters) High Range SPS20 & SPS30 Series Pulverizer Seeders 313-242M 6/26/02...
Page 21
Wheatgrass - Crested (Kilograms per 1000 Square Meters) High Range Low Range Wheatgrass - Western (Kilograms per Hectare) High Range Low Range Wheatgrass - Western (Kilograms per 1000 Square Meters) High Range Low Range 6/26/02 SPS20 & SPS30 Series Pulverizer Seeders 313-242M...
2. Be sure that the seedbox is completely cleaned before storing. Lubrication Lubrication Multi-purpose Multi-purpose Multi-purpose Intervals at which spray lube grease lube oil lube lubrication is required Legend Feed Cup Drive Shaft Type of Lubrication: Oil 18531 Quantity = Generously SPS20 & SPS30 Series Pulverizer Seeders 313-242M 6/26/02...
Land Pride Section 4 Maintenance and Lubrication Wheel Bearings Type of Lubrication: Multi-Purpose 18492 Quantity = Coat Generously Required Roller Chains (4 chains) Type of Lubrication: Chain Lubricant 18497 Quantity = Generously 6/26/02 SPS20 & SPS30 Series Pulverizer Seeders 313-242M...
20 Series: H Beam-10”; 30 Series: H Beam-12” 10 1/2” x 2” x 1/2” Scarifier teeth Scarifier teeth are heat-treated for long life and can be reversed when one side wears down. SPS20 & SPS30 Series Pulverizer Seeders 313-242M 6/26/02...
Check for trash or mud buildup on roller end. Seed does not meter. Clutch not engaged. See Clutch Engagement (Disengagement) page 11 Figure 3-6 Shanks bending sideways Lift shanks out of ground when turning 6/26/02 SPS20 & SPS30 Series Pulverizer Seeders 313-242M...
Overall Unit: One year Parts and Labor Ripper shanks and roller studs are considered wear items This Warranty is limited to the replacement of any defective part by Land Pride and the installation by the dealer of any such replacement part, and does not cover common wear items such as blades, belts, tines, etc.